A portable A2 drawing board with a smooth laminated surface for sketching, drafting and brainstorming at events, training rooms and children's activity zones.
It rents ready to use, so you get a firm, clean flat surface without buying one for a one-off job.
This is a flat, rigid drawing and drafting board built for hand drawing, sketching and layout work.
It is an A2-size board, roughly 610 mm x 762 mm (about 24 in x 30 in), made of laminated wood or plywood with a smooth drafting surface.
That surface resists ink and wipes clean of pencil and eraser marks, and the board stays rigid and level so paper sits perfectly flat through a long session.
The side edges are machined straight, so a T-square or set square slides cleanly along the board to draw accurate horizontal and vertical reference lines.
It is a fully manual board with no power, no motor and no electronics; you simply place it on a desk or table, or prop it against a wall or table edge, and start drawing.
The flat working surface holds A2, A3 or A1 cartridge sheets with room for a border and a title block, and you secure the paper with drawing pins, masking tape or bulldog clips without marking the board.
It is light enough to carry between a home, a studio and a class, yet firm enough to keep the sheet steady while you work.
This is a plain board on its own: it does not come with a drafting stand, an easel or a parallel-motion bar, and markers, pens, paper and pins are not included.
It is best used indoors, kept dry and stored flat, because the wood and laminate surface can swell, warp or stain if it gets wet.
Sizes and finishes vary slightly by unit; all figures here are estimated and confirmed on the day of hire.