Run four XLR audio or DMX lighting channels over one network cable
A signal extender that carries four channels of 3-pin balanced audio or DMX512 lighting control down a single shielded Cat5 or Cat6 network cable.
Instead of running four bulky, expensive XLR cables across a venue, you run one light, inexpensive data cable, which is faster to lay, easier to tape down and cheaper to replace.
Used as a send-and-return pair, it extends audio snakes to front of house or lighting-control lines to the rig over long distances.
It is passive and pass-through, so there is nothing to configure, which makes it a go-to for live stages, lighting setups and recording studios.
Why Choose This Product
- Four channels over one cable: carry four XLR audio or DMX512 lines on a single shielded Cat5/Cat6 run.
- Cheaper, lighter runs: network cable is far lighter and cheaper than four long XLR cables.
- Audio or lighting: works for balanced audio snakes and DMX512 lighting control alike.
- Long distance: shielded (STP) cable keeps signals clean over long venue runs.
- Passive and simple: pass-through pair with nothing to power or program.
How Can You Use This
- Stage lighting DMX runs: send DMX512 to lighting fixtures across the venue on one cable.
- Multichannel audio snake: extend four audio lines to front of house or a recorder.
- Recording studios: route balanced lines between rooms over structured cabling.
- Live events and concerts: simplify stage wiring and speed up get-in and get-out.
- Temporary installs: reuse existing network cable to carry audio or control signals.
What's Included
- 1× XLR / DMX512 Signal Extender Pair (Send + Return)
